BLR100-112DG
- Introduction
- Parameters
·Adopt high quality high sensitive optical
detector and gallium arsenide RF amplification module to ensure low noise, low
distortion and high capability and reliability.
·Controlled by optical AGC, when input optical
power is -7-+2dBm, output power level and CTB, CSO remain unchanged.
·Interface reserved for return transmission module
installed. The module power is 1mW-3mW, and there are two interface type, FC/APC
and SC/APC, for choice.
·Adopt wide range, low heating power switch
to meet the different workplace and voltage requirement. For stability of the
product, we recommend 60V power switch.
·Plexer filter’s positive and negative
frequency divider, 5 – 30/47 – 750(862); 5- 65/87 – 750(862) optional.
·Network management interface preset.
ITEM |
UNIT |
PARAMETER |
Optical Operating Wavelength |
nm |
1290-1600 |
Input Optical Power Range |
dBm |
-9 - +3 |
Optical AGC Range |
dBm |
-7 - +2 |
Optical Return Loss |
dB |
≥45 |
Equivalent Noise Coefficient |
PA√Hz |
≤8 |
RF operating Length |
MHz |
87 – 862/1000 |
Flatness |
dB |
±0.75 |
Return Loss |
dB |
≥16 |
RF Input Impedance |
Ω |
75 |
CNR |
dB |
51 |
ITEM |
UNIT |
PARAMETER |
CTB |
dB |
≥65 |
CSO |
dB |
≥60 |
Output Power Level |
dBuV |
108(-7dBm- +2dBm) |
Output Test Port Power Level |
dBuV |
-20 |
Output Port Number |
PCS |
2 |
AC Input Voltage Range |
VAC |
40-95/140-265 |
Operating Temperature |
℃ |
-40 - +60 |
Consumption |
W |
<35 |
Dimension (Not Include Head F) |
mm |
325(L)*220(W)*130(H) |